[VoiceOps] VoIP Testing

Mark Wiater mark.wiater at greybeam.com
Tue May 23 17:32:01 EDT 2017


I currently use Celeron or Atom based single board devices.

https://www.amazon.com/Jetway-Networking-Appliance-Embedded-JBC373F38W-525/dp/B00ESMUF7O 
are pretty OK.

There's also a celeron model. They both have 4 interfaces.

On 5/23/2017 5:20 PM, Shripal Daphtary wrote:
> Mark, what type of device are you using as the sensor?
>
> I've been looking for a raspberry pi with two Ethernet interfaces but I can't seem to find one.
>
> I'm assuming we need on port for port mirror traffic and one for internet access to send the data back to voipmonitor.
>
>
>
> Thanks,
>
> Shripal
>
>> On May 23, 2017, at 3:49 PM, Mark Wiater <mark.wiater at greybeam.com> wrote:
>>
>>
>>>  From time to time we have some remote clients who are facing voice quality issues on their endpoints and I have no real good way of troubleshooting or pin pointing the problem.
>> While it's not completely free, I couldn't live without voipmonitor for this very use. I install a sensor in the client network on a mirror port or on the phone system and get to see exactly what they see, from a voip perspective.
>>
>> The collection software is open source but the gui is invaluable.
>>
>>
>>
>> _______________________________________________
>> VoiceOps mailing list
>> VoiceOps at voiceops.org
>> https://puck.nether.net/mailman/listinfo/voiceops



More information about the VoiceOps mailing list