[VoiceOps] Old PA System setup

[Jake Clappton]

Take an old IP phone and clip the speaker wire – connect the speaker wire to your audio pairs… you can daisy chain to all of them
Put a screw or tape the hookflash down
Set your page key up to intercom call that IP phone
Cheapest way I know.




Regards,
Jake Clappton
Intelecom, Inc / voipdesk
925.701.3008 - Direct
925.846.8025 - eFax
www.voipdesk.com<http://www.voipdesk.com/>




From: VoiceOps <voiceops-bounces at voiceops.org> On Behalf Of Darin Steffl
Sent: Thursday, April 18, 2019 3:40 PM
To: VoiceOps <voiceops at voiceops.org>
Subject: [VoiceOps] Old PA System setup

Hey guys,

https://www.valcom.com/pdf/v1030c_v1036c.pdf

We're trying to find the best way to interface 3 old Valcom speakers V-1030c to an IP paging system.

I have a Snom PA1 but that won't work as we initially thought because speakers need 4 wires on a 24v power system. So 2 wires are for 24v power, and the other 2 are for audio. The snom only has a positive and negative output that feeds passive speakers, not active speakers like these.

What is the best way to utilize these 3 speakers or should we just replace the speakers? We're trying to keep budget to a minimum for them so we would prefer to utilize the same speakers but what's the best way to power them and feed them audio using the existing 2-pair RJ11 cable they use?

Thank you

--
Darin Steffl
Minnesota WiFi
www.mnwifi.com<http://www.mnwifi.com/>
507-634-WiFi
[http://www.snoitulosten.com/wp-content/uploads/2010/01/facebook-small.jpg]<http://www.facebook.com/minnesotawifi> Like us on Facebook<http://www.facebook.com/minnesotawifi>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/voiceops/attachments/20190418/09aab317/attachment-0001.html>