[cisco-voip] i add phone to SW and a ephone creates auto

[Aaron Kent]

If you delete a phone out it leave the ephone registration in until
power is cycled. There is no way to clear it. If you have 1-10 and 3 has
been removed, then the next phone will be ephone 11. No reason why this
is there, other than a virtual register for ephone will not clear until
power is cycled. At power cycle, that ephone 3 will be available for the
next phone.


-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of James Grace
Sent: Friday, March 25, 2005 4:20 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] i add phone to SW and a ephone creates auto 


I have cme 3.2.1 on  a 3725 router with iso 12.11.3xl

After I configured cme in a testing lab, I notices that if I plug a new
phone into my switch - cme adds another ephone.  So I started with 10
ephones in my config files.  I add a new phone to sw .  the new phone
goes thru the startup (dhcp, load, etc ). And then its up with no dn
assigned to it.   the reason that this is a issue is when I go to for
example ephone3 and try to put in a mac-address, it errors out saying
"cant use same  mac on multiple ephones , ephone 11 already has this
mac.  I spoke to cisco rep and they say this is not suppose to happen.
So my question is anybody know why.   I guess it fine that it get an IP
address from the dhcp pool.  But why create a ephone in cme 


---



_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip