[cisco-voip] 7970G - Brightness display/display not active
Bob A. Bowie
bababooey at cox.net
Sun Jun 11 23:15:03 EDT 2006
It is a 3550, does it supply the 15watts?
Yes, but how can I make the default when creating the phone to change the
display to be active all the time.
So I don't have to go down and uncheck it every time.
THanks
----- Original Message -----
From: "Craig M Staffin" <CMStaffin at ra.rockwell.com>
To: "Bob A. Bowie" <bababooey at cox.net>
Cc: <cisco-voip at puck.nether.net>; <cisco-voip-bounces at puck.nether.net>
Sent: Sunday, June 11, 2006 10:10 PM
Subject: Re: [cisco-voip] 7970G - Brightness display/display not active
> Bob,
>
> What switch is this connected to. If it is an older switch that can not
> supply the full 15 watts the display will be dim. This can be corrected
> with a 3560 or a power brick.
>
> Also if you log inot callmanager you can change when the display will be
> active or not
>
> Craig
>
>
>
>
>
> "Bob A. Bowie"
> <bababooey at cox.ne
> t> To
> Sent by: <cisco-voip at puck.nether.net>
> cisco-voip-bounce cc
> s at puck.nether.net
> Subject
> [cisco-voip] 7970G - Brightness
> 06/11/2006 09:04 display/display not active
> PM
>
>
>
>
>
>
>
>
>
> 1. The brightness display on my 7970 does not allow for upward
> adjustment,
> the bar is currently set less than halfway up?
>
> 2. How can I set the default phone config to change the default to have
> the
> phone display active always,
> the default is to blank the display on Sunday???
>
> Thanks
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
>
More information about the cisco-voip
mailing list