[cisco-voip] Fast Busy on International Calls When Using Route List
Stu Packett
SPackett at fenwick.com
Wed Mar 8 18:29:55 EST 2006
I had to change it NATIONAL and ISDN for it to work. Strange, but the
VG200s we had previously were all set to "Cisco CallManager" and worked
just fine. The "Unknown" didn't work either. Thanks everyone.
-----Original Message-----
From: Erick Bergquist [mailto:erickbe at yahoo.com]
Sent: Friday, March 03, 2006 10:03 AM
To: Wes Sisk; Stu Packett
Cc: erickbe at yahoo.com; cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Fast Busy on International Calls When Using
Route List
Also, your successful call is going out with type of ISDN and national
... depends on PBX like wes said.
>From my experiences, setting the CALLED PARTY number isdn type and plan
to unknown and unknown seems to work with for most numbers on most
systems I've worked on but YMMV depending on PBX or carrier.
--- Wes Sisk <wsisk at cisco.com> wrote:
> depending on the type of PBX you're connecting to, some like type =
> international to have the leading 011 stripped.
>
> /Wes
>
> Stu Packett wrote:
> > Here is an updated failed and successful call
> debug:
> >
> > SF-PRIGW3#debug isdn q931
> > debug isdn q931 is ON.
> >
> > FAILED-USING ROUTE LIST
> > SF-PRIGW3#
> > *Mar 3 15:45:33.086: ISDN Se0/0/0:23 Q931:
> pak_private_number: Invalid
> > type/plan 0x0 0x1 may be overriden; sw-type 3 *Mar 3 15:45:33.090:
> > ISDN Se0/0/0:23 Q931:
> Applying typeplan for
> > sw-type 0x3 is 0x2 0x1, Calling num 4158752300 *Mar 3 15:45:33.090:
> > ISDN Se0/0/0:23 Q931:
> Applying typeplan for
> > sw-type 0x3 is 0x1 0x1, Called num 01185227220270 *Mar 3
> > 15:45:33.090: ISDN Se0/0/0:23 Q931: TX ->
> SETUP pd = 8 callref
> > = 0x0722
> > Bearer Capability i = 0x8090A2
> > Standard = CCITT
> > Transfer Capability = Speech
> > Transfer Mode = Circuit
> > Transfer Rate = 64 kbit/s
> > Channel ID i = 0xA98397
> > Exclusive, Channel 23
> > Calling Party Number i = 0x2181,
> '4158752300'
> > SF-PRIGW3#
> > Plan:ISDN, Type:National
> > Called Party Number i = 0x91,
> '01185227220270'
> > Plan:ISDN, Type:International *Mar 3 15:45:33.182:
> > ISDN Se0/0/0:23 Q931: RX <-
> CALL_PROC pd = 8
> > callref = 0x8722
> > Channel ID i = 0xA98397
> > Exclusive, Channel 23 *Mar 3 15:45:33.186: ISDN
> > Se0/0/0:23 Q931: RX <-
> PROGRESS pd = 8
> > callref = 0x8722
> > Cause i = 0x829F - Normal, unspecified
> > Progress Ind i = 0x8488 - In-band info or
> appropriate now
> > available
> > SF-PRIGW3#
> > *Mar 3 15:45:38.318: ISDN Se0/0/0:23 Q931: TX ->
> DISCONNECT pd = 8
> > callref = 0x0722
> > Cause i = 0x8090 - Normal call clearing *Mar 3
> > 15:45:38.346: ISDN Se0/0/0:23 Q931: RX <-
> RELEASE pd = 8
> > callref = 0x8722
> > *Mar 3 15:45:38.350: ISDN Se0/0/0:23 Q931: TX ->
> RELEASE_COMP pd = 8
> > callref = 0x0722
> > SF-PRIGW3#
> > *Mar 3 15:46:44.334: ISDN Se0/0/0:23 Q931:
> pak_private_number: Invalid
> > type/plan 0x0 0x1 may be overriden; sw-type 3 *Mar 3 15:46:44.334:
> > ISDN Se0/0/0:23 Q931:
> pak_private_number: Invalid
> > type/plan 0x0 0x0 may be overriden; sw-type 3 *Mar 3 15:46:44.338:
> > ISDN Se0/0/0:23 Q931:
> Applying typeplan for
> > sw-type 0x3 is 0x2 0x1, Called num 01185227220270 *Mar 3
> > 15:46:44.338: ISDN Se0/0/0:23 Q931: TX ->
> SETUP pd = 8 callref
> > = 0x0723
> > Bearer Capability i = 0x8090A2
> > Standard = CCITT
> > Transfer Capability = Speech
> > Transfer Mode = Circuit
> > Transfer Rate = 64 kbit/s
> > Channel ID i = 0xA98397
> > Exclusive, Channel 23
> > Calling Party Number i = 0x2181,
> '4158752300'
> >
> > SUCCESS-USING ROUTE PATTERN
> > SF-PRIGW3#
> > Plan:ISDN, Type:National
> > Called Party Number i = 0xA1,
> '01185227220270'
> > Plan:ISDN, Type:National *Mar 3 15:46:44.382: ISDN
> > Se0/0/0:23 Q931: RX <-
> CALL_PROC pd = 8
> > callref = 0x8723
> > Channel ID i = 0xA98397
> > Exclusive, Channel 23 SF-PRIGW3# *Mar 3
> > 15:46:46.638: ISDN Se0/0/0:23 Q931: RX <-
> ALERTING pd = 8
> > callref = 0x8723
> > Progress Ind i = 0x8488 - In-band info or
> appropriate now
> > available
> > SF-PRIGW3#
> > *Mar 3 15:46:55.490: ISDN Se0/0/0:23 Q931: TX ->
> DISCONNECT pd = 8
> > callref = 0x0723
> > Cause i = 0x8090 - Normal call clearing *Mar 3
> > 15:46:55.506: ISDN Se0/0/0:23 Q931: RX <-
> RELEASE pd = 8
> > callref = 0x8723
> > *Mar 3 15:46:55.510: ISDN Se0/0/0:23 Q931: TX ->
> RELEASE_COMP pd = 8
> > callref = 0x0723
> >
> > -----Original Message-----
> > From: Erick Bergquist [mailto:erickbe at yahoo.com]
> > Sent: Wednesday, March 01, 2006 7:40 PM
> > To: Stu Packett; cisco-voip at puck.nether.net
> > Subject: Re: [cisco-voip] Fast Busy on
> International Calls When Using
> > Route List
> >
> > Is the debug for the failed or good call? I am
> guessing the bad call? Do
> > you see q931 output on the call with fast busy?
> >
> > Can you post a q931 debug for the good call if
> that is for bad? It looks
> > like
> >
> > I am seeing the call setup, then a progress
> received from carrier
> > followed by the router sending a disconnect out.
> >
> > Are the bad and good call using same dial-peers on
> gateway?
> >
> > --- Stu Packett <SPackett at fenwick.com> wrote:
> >
> >
> >> CallManager 4.0(2a)
> >> 2811 Gateway 12.4.5 IP Voice IOS
> >>
> >> Two of my gateways in my other office is giving
> international calls a
> >> fast busy. If I manually create a route pattern
> for that
> >> international number to use those gateways, the
> calls goes through
> >> just fine. Once I remove that route pattern and
> have the call use the
> >>
> >
> >
> >> route list, I get a fast busy. I changed the
> order of my route list
> >> to use both gateways first, but still the same
> problem. Below is a
> >> 'debug isdn q931'. Any thoughts? Thanks in
> advance.
> >>
> >> SF-PRIGW2#debug isdn q931
> >> debug isdn q931 is ON.
> >> SF-PRIGW2#
> >> *Mar 1 19:52:28.029: ISDN Se0/0/1:23 Q931:
> >> pak_private_number: Invalid
> >> type/plan 0x0 0x1 may be overriden; sw-type 3
> *Mar 1 19:52:28.029:
> >> ISDN Se0/0/1:23 Q931: Applying typeplan for
> sw-type 0x3 is 0x2 0x1,
> >> Calling num 4158752300 *Mar 1 19:52:28.029: ISDN
> Se0/0/1:23 Q931:
> >> Applying typeplan for sw-type 0x3 is 0x1 0x1,
> Called num
> >> 01185227220270 *Mar 1 19:52:28.029: ISDN
> Se0/0/1:23 Q931: TX -> SETUP
> >>
> >
> >
> >> pd = 8 callref = 0x0299
> >> Bearer Capability i = 0x8090A2
> >> Standard = CCITT
> >> Transfer Capability = Speech
> >> Transfer Mode = Circuit
> >> Transfer Rate = 64 kbit/s
> >> Channel ID i = 0xA98397
> >> Exclusive, Channel 23
> >> Calling Party Number i = 0x2181,
> '4158752300'
> >> SF-PRIGW2#
> >> Plan:ISDN, Type:National
> >> Called Party Number i = 0x91, '01185227220270'
> >> Plan:ISDN, Type:International
> *Mar 1 19:52:28.069:
> >> ISDN Se0/0/1:23 Q931: RX <- CALL_PROC pd = 8
> callref = 0x8299
> >> Channel ID i = 0xA98397
> >> Exclusive, Channel 23 *Mar 1 19:52:28.073: ISDN
> >> Se0/0/1:23 Q931: RX <-
> PROGRESS pd = 8
> >> callref = 0x8299
> >> Cause i = 0x829F - Normal, unspecified
> >> Progress Ind i = 0x8488 - In-band info or
> appropriate now
> >> available SF-PRIGW2# *Mar 1 19:52:29.849: ISDN
> Se0/0/1:23 Q931: TX ->
> >>
> >
> >
> >> DISCONNECT pd = 8 callref = 0x0299
> >> Cause i = 0x8090 - Normal call clearing
> *Mar 1 19:52:29.877:
> >> ISDN Se0/0/1:23 Q931: RX <- RELEASE pd = 8
> callref = 0x8299 *Mar 1
> >> 19:52:29.881: ISDN Se0/0/1:23 Q931: TX ->
> RELEASE_COMP pd = 8 callref
> >> = 0x0299
> >>
> >>
> >> Disclaimer: If you have received this message in
> error, call (650)
> >> 988-8500 and delete or destroy any copy of this
> message.
> >>
> >>
> >>> _______________________________________________
> >>>
> >> cisco-voip mailing list
> >> cisco-voip at puck.nether.net
> >>
> https://puck.nether.net/mailman/listinfo/cisco-voip
> >>
> >>
> >
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Tired of spam? Yahoo! Mail has the best spam
> protection around
> > http://mail.yahoo.com
> >
> > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> >
> https://puck.nether.net/mailman/listinfo/cisco-voip
> >
>
>
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
More information about the cisco-voip
mailing list