[cisco-voip] Paging system

[Voice Noob]

I have an extra FXO port but if it works with FXS getting dial tone then I
wouldn't think it would use an FXO? I have not done very many overhead
paging systems. Just IP phone based with Berbee and such. THanks for
everyones help.

On Wed, Jun 25, 2008 at 8:09 PM, Lelio Fulgenzi <lelio at uoguelph.ca> wrote:

> get one of these and it will fix things up
>
> http://www.bogen.com/products/pdfs/telephonepagepdfs/TAMBs.pdf
>
> there are alternatives, like the ones from valcom, but i've used the tamb
> and they work great. the disconnect issue is because of the FXS port and if
> you had a trunk port or FXO port it would likely work without it, but with
> an FXS port you need this for sure.
>
> ----- Original Message -----
> From: "Voice Noob" <voicenoob at gmail.com>
> To: cisco-voip at puck.nether.net
> Sent: Wednesday, June 25, 2008 4:18:14 PM GMT -07:00 US/Canada Mountain
> Subject: Re: [cisco-voip] Paging system
>
>
> I think it is a MUZAK paging.
>
>
> On Wed, Jun 25, 2008 at 5:05 PM, Voice Noob < voicenoob at gmail.com > wrote:
>
>
> I have a very ancient paging system that we found out about at the 11th
> hour of a cut over to CUCM 6.1. I can connect an FXS port to it and it pages
> once but does not dissconnect. What are some things I can try on the 2821
> gateway to make it dissconnect? Thanks for your help.
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20080625/de41629d/attachment.html>