connect TX on one end to RX on the other and vice-versa.
configure one of the routers for "clocking internal".
cheers,
lincoln.
At 02:28 PM 25/05/2002 +0800, Prads wrote:
>Hi,
>
>How should the interfaces be configured then? Should one be configured
>user and the other network? Can you guide me ho to do it? Also, should
>the tx/rx pairs be swapped on the other interface?
>
>Thanks in advance from a greenie.
>
>Prads
>
>-----Original Message-----
>From: Michael Damkot [mailto:mdamkot@UU.NET]
>Sent: Saturday, May 25, 2002 1:09 PM
>To: Prads
>Cc: cisco-nsp@puck.nether.net
>Subject: Re: [nsp] ATM interfaces...
>
>yes
>
>--
>
>Cheers,
>Michael Damkot CCNP
>Technical Trainer
>Network Engineer
>
>On Sat, 25 May 2002, Prads wrote:
>
> > Date: Sat, 25 May 2002 10:32:54 +0800
> > From: Prads <drix@pilnet.com>
> > To: cisco-nsp@puck.nether.net
> > Subject: [nsp] ATM interfaces...
> > Resent-Date: Fri, 24 May 2002 22:36:03 -0400
> > Resent-From: cisco-nsp@puck.nether.net
> >
> > Hi,
> >
> > Is it possible to connect atm interfaces back-to-back without an atm
> > switch in between?
> >
> > Thanks!
> >
> > Prads
> >
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:11:58 EDT