Re: [nsp] dCEF does not start on the VIPs 2-50

• Next message: Vinod Anthony Joseph Cherunni: "[nsp] REG: OSPF routes"
• Previous message: Dave Curado: "Re: [nsp] OSPF equal-cost multipath"
• Maybe in reply to: Strakadounas Kostas: "[nsp] dCEF does not start on the VIPs 2-50"
• Next in thread: Arie Vayner: "RE: [nsp] dCEF does not start on the VIPs 2-50"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

George Robbins said:

  I'd suggest upgrade the VIP's to 64M for VIP2's and 64 or 128M for VIP2/50's.
  Otherwise the line cards will run out of memory shut down CEF. In those
  versions, there's not much control of CEF, just "no ip cef" off-hours and
  bring back up.

RAM for big dCEF tables is important if you have full routes.
Otherwise, your problem is probably something else. Cisco
has some more quantitative advice at:

  http://www.cisco.com/warp/public/cc/pd/rt/7500/prodlit/mmry_wp.htm

-jim warner
UC Santa Cruz

• Next message: Vinod Anthony Joseph Cherunni: "[nsp] REG: OSPF routes"
• Previous message: Dave Curado: "Re: [nsp] OSPF equal-cost multipath"
• Maybe in reply to: Strakadounas Kostas: "[nsp] dCEF does not start on the VIPs 2-50"
• Next in thread: Arie Vayner: "RE: [nsp] dCEF does not start on the VIPs 2-50"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:24 EDT