Re: [nsp] ip route-cache flow per subinf allowed?

• Next message: Vinod Anthony Joseph Cherunni: "[nsp] REG: OSPF PE-CE support for MPLS VPN's"
• Previous message: John Payne: "Re: [nsp] ip route-cache flow per subinf allowed?"
• Maybe in reply to: Hank Nussbacher: "[nsp] ip route-cache flow per subinf allowed?"
• Next in thread: dhudson: "Re: [nsp] ip route-cache flow per subinf allowed?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

Hi,

"ip route-cache flow" cannot be enabled at the sub-interface level, & can
only be enabled at the physical interface. Actually enabling it at the
physical interface should do fine.

The command "show ip cache flow" should confirm the working results.

Cisco has confirmed the operation of Netflow switching on the following
scenarios.

Frame Relay subinterfaces
ATM subinterfaces
Inter-Switch Link (ISL) subinterfaces
802.1q subinterfaces
Multilink PPP interfaces
Generic Routing Encapsulation (GRE) tunnel interfaces
Layer 2 Tunneling Protocol (L2TP) VPDN-group interfaces
MPLS-VPN interfaces
Tunnel Hopping

Hope this helps.

With warm regards,

Vinod.

• Next message: Vinod Anthony Joseph Cherunni: "[nsp] REG: OSPF PE-CE support for MPLS VPN's"
• Previous message: John Payne: "Re: [nsp] ip route-cache flow per subinf allowed?"
• Maybe in reply to: Hank Nussbacher: "[nsp] ip route-cache flow per subinf allowed?"
• Next in thread: dhudson: "Re: [nsp] ip route-cache flow per subinf allowed?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:33 EDT