There are two ways to configure a PVC on an ATM interface.
"atm pvc" or just "pvc". WHat is the diffence.
I have found that using just "pvc" to define the circuit and then
configuring oam etc, the interface link state changes correctly.
When I use the atm pvc command and add oam to the end the link state does
not change. Do I need to configure oam on the physical interface too.
Or is this just the way it is?
Thanks in advance.
Later
Jon
**********************************************************************
COLT Telecommunications
Registered in England No. 2452736
Registered Office: Bishopsgate Court, 4 Norton Folgate, London E1 6DQ
Tel. 020 7390 3900
This message is subject to and does not create or vary any contractual
relationship between COLT Telecommunications, its subsidiaries or
affiliates ("COLT") and you. Internet communications are not secure
and therefore COLT does not accept legal responsibility for the
contents of this message. Any view or opinions expressed are those of
the author. The message is intended for the addressee only and its
contents and any attached files are strictly confidential. If you have
received it in error, please telephone the number above. Thank you.
**********************************************************************
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:35 EDT