You can use CAR if necessary . I would recommend you
use the rate-limit command and provide traffic shapping on your RAS
circuits.
If you would like some more information email me directly and I could help
you with it.
Thanks.
==DMT>
-----Original Message-----
From: Charles Sprickman [mailto:spork@inch.com]
Sent: Thursday, September 13, 2001 12:00 AM
To: cisco-nsp@puck.nether.net
Subject: [nsp] traffic shaping help
Hi,
I'm looking for a quick handout, and I won't be bashful about asking :)
Due to events in NYC, I've lost backhaul to a dial pop. I'm working on
getting 8 POTS lines trunked together between two USR/3com RAS boxes.
This is pretty pitiful bandwidth...
Given that I know the address ranges, and that there's a Cisco upstream of
the RAS box, is there anything that can rate shape on a per-ip basis?
Meaning each single IP rate-shaped/limited/whatever to say 14,400
bits/sec?
Or any other suggestions? POTS is really the only link I can get between
locations.
Thanks,
Charles
| Charles Sprickman | Internet Channel
| INCH System Administration Team | (212)243-5200
| spork@inch.com | access@inch.com
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:50 EDT