On the fiber make sure you have the transmit and receive correct:
router: 6500
RED (TX) -> (RX) BLUE
BLUE (RX) -> (TX) RED
This should bring the link up. Gig is full duplex, you can not set it to
half.
==DMT>
-----Original Message-----
From: Benjie Ko [mailto:gerwalk1@yahoo.com]
Sent: Tuesday, September 11, 2001 4:23 AM
To: cisco-nsp@puck.nether.net
Subject: [nsp] routed interface on 6509
Hi,
I have successfully moved from hrybrid to native IOS
on
our 6509/sup2/msfc2. I am currently running
12.1(8a)E3.
Now im setting up my uplink to the rest of the
network. I will connect to a 7206vxr via GigE.
Assigned a /30 on both interfaces. My config on the
gigE interface of the 6509 is just the ip address.
Same case for the gigE of 7200 except for "no
negotiation auto".
7200 gigE shows GigE up line protocol up but 6509 is
GigE up line protocol down.
They are connected with a tested and
known-to-be-working fiber optic patch cable.
Is this correct?
__________________________________________________
Do You Yahoo!?
Get email alerts & NEW webcam video instant messaging with Yahoo! Messenger
http://im.yahoo.com
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:50 EDT