[nsp] odd interface problem

From: Phil Bedard (philb@cyberlynk.net)
Date: Thu Nov 01 2001 - 11:00:44 EST

Next message: Robert E. Seastrom: "Re: [nsp] Is PA-GE supported on 7500 ?"
Previous message: Birsen Ozturk: "[nsp] OSPF Load balance question"
Next in thread: Dmitri Kalintsev: "Re: [nsp] odd interface problem"
Reply: Dmitri Kalintsev: "Re: [nsp] odd interface problem"
Maybe reply: Phil Bedard: "[nsp] odd interface problem"
Reply: Dmitri Kalintsev: "Re: [nsp] odd interface problem"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This is on a CT3 card on a 7513 running 12.0(10)S, for
whatever reason doing a "show ip int brief" results in this:

Serial1/0/0:15 10.10.10.10 YES NVRAM up up
Serial1/0/0:16 10.10.10.10 YES NVRAM up up
Serial1/0/0/-1:-1 unassigned YES manual down down
Serial1/0/0:18 10.10.10.10 YES NVRAM up up

You also can't do a specific show int of any of the serial interface on
that CT3. IE: show int Serial1/0/0:18 gives an invalid input error. The
other interfaces also can't be configured. Anyone seen this before?

Thanks,

Phil

Next message: Robert E. Seastrom: "Re: [nsp] Is PA-GE supported on 7500 ?"
Previous message: Birsen Ozturk: "[nsp] OSPF Load balance question"
Next in thread: Dmitri Kalintsev: "Re: [nsp] odd interface problem"
Reply: Dmitri Kalintsev: "Re: [nsp] odd interface problem"
Maybe reply: Phil Bedard: "[nsp] odd interface problem"
Reply: Dmitri Kalintsev: "Re: [nsp] odd interface problem"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:53 EDT