I have Catalyst 8510 MSR with 4 port ATM/OC3 card. If I
do something like that:
cat8540#conf t
Enter configuration commands, one per line. End with CNTL/Z.
cat8540(config)#int atm 0/0/0
cat8540(config-if)#sonet stm-1
cat8540(config-if)#
atm interface will be look's like that:
cat8540#sh controllers atm 0/0/0
IF Name: ATM0/0/0 Chip Base Address: A8808000
Port type: OC3 Port rate: 155000 Kbps Port medium: SM Fiber
Port status:SECTION LOS Loopback:None Flags:8300
TX Led: Traffic Pattern RX Led: Traffic Pattern
TX clock source: network-derived
Framing mode: stm-1
And the question is: Is "sonet stm-1" command is enough to use
this ATM port as STM-1 Sonet/SDH port ?
btw. I looked in Cisco Pricing Spreadsheet and I didn't see Sonet/SDH
cards for Cat8510, maybe I'm blind....
t.
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:03 EDT