RE: [nsp] throttle BW on one port of Catalyst 3524XL

• Next message: Brian Whalen: "Re: [nsp] Cisco 2620 : status up protocol down"
• Previous message: jp@pour.midcoast.com: "Re: [nsp] BGP advertisement + route maps"
• Maybe in reply to: Dave VanAuken: "[nsp] throttle BW on one port of Catalyst 3524XL"
• Next in thread: kevin graham: "Re: [nsp] throttle BW on one port of Catalyst 3524XL"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

Hi

We have been looking into this, and a Cisco CE has offered us to check
'port storm-control unicast'
It enables you to control the frames/sec rate. It's not the exact thing
you look for, but is better than nothing.
Also, you could look into 2948G-L3

Arie

-----Original Message-----
From: Dave VanAuken [mailto:dave@hawk-systems.com]
Sent: Monday, October 15, 2001 02:55
To: cisco-nsp@puck.nether.net
Subject: [nsp] throttle BW on one port of Catalyst 3524XL

Have an NT box going on our network, wish to throttle the FastEthernet
port that it is on to 1mb max. Have set "bandwidth 1000" in the
interface config... can I assume that is sufficient to allow it a
maximum of 1mb bi-directional bandwidth?

thx

Dave

• Next message: Brian Whalen: "Re: [nsp] Cisco 2620 : status up protocol down"
• Previous message: jp@pour.midcoast.com: "Re: [nsp] BGP advertisement + route maps"
• Maybe in reply to: Dave VanAuken: "[nsp] throttle BW on one port of Catalyst 3524XL"
• Next in thread: kevin graham: "Re: [nsp] throttle BW on one port of Catalyst 3524XL"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:20 EDT