I see i made a cut and paste mistake in previous message. the right config
is:
policy-options {
policy-statement ospf-to-bgp {
term 1 {
from protocol ospf;
then accept;
}
}
}
protocols {
bgp {
log-updown;
export ospf-to-bgp;
group 52-72 {
type external;
peer-as 65500;
neighbor 192.168.201.225;
}
}
> > -----Messaggio originale-----
> > Da: eedmgu@eed.ericsson.se [mailto:eedmgu@eed.ericsson.se]
> > Inviato: lunedi 11 giugno 2001 16.26
> > A: juniper-nsp@puck.nether.net
> > Oggetto: [j-nsp] BGP-OSPF route redistribution
> >
> >
> > Hi,
> >
> > I'm new to Juniper routers, so please forgive me if this is a FAQ (I
> > couldn't find anything in the digest):
> >
> > I'm trying to set up an M40 to redistribute routes from OSPF to BGP,
> > exchanging with a Cisco 7507. The M40 sees the routes from
> > the Cisco just
> > fine, but the Cisco doesn't receive anything. Is there
> anything I need
> > to do to emulate the Cisco "redistribute ospf <...>" statement?
> >
> > The relevant bits of the configs are below. Thanks in
> advance for any
> > help!
> >
> > - Markolf
> >
> > *** Cisco:
> >
> > interface ATM1/0/0.8 point-to-point
> > ip address 192.168.201.225 255.255.255.252
> > pvc 100/38
> > vbr-nrt 103515 51757 10000
> > encapsulation aal5snap
> > !
> > router bgp 65500
> > bgp log-neighbor-changes
> > redistribute ospf 100
> > [neighbours...]
> > neighbor 192.168.201.226 remote-as 64000
> > no auto-summary
> > !
> >
> > *** Juniper:
> >
> > interfaces {
> > at-1/0/0 {
> > unit 0 {
> > encapsulation atm-snap;
> > vci 100.38;
> > family inet {
> > address 192.168.201.226/30;
> > }
> > }
> > }
> > fe-6/0/0 {
> > unit 0 {
> > family inet {
> > address 10.0.24.253/24;
> > }
> > }
> > }
> > }
> > protocols {
> > bgp {
> > log-updown;
> > group 52-72 {
> > type external;
> > peer-as 65500;
> > neighbor 192.168.201.225;
> > }
> > }
> > ospf {
> > area 0.0.0.0 {
> > interface fe-6/0/0.0;
> > interface at-1/0/0.0;
> > }
> > }
> > }
> >
> >
>
This archive was generated by hypermail 2b29 : Mon Aug 05 2002 - 10:42:37 EDT