Milled (?) Lettering in Wrinkle Paint

[Fred e holnagel]

Re. the lettering on Command sets etc.  Definately engraved. As the owner
of three manual engravers, I frequently do custom panel work for
aircraft, marine, and commercial electricians.  In a fairly hard but not
brittle substrate of uniform thickness, a .015 cutter set to about .001
deeper than the paint itself will make these letters.  I will look around
for a piece of wrinkle finish to try. My spindle speed is as high as
10000 rpm. I also do the vanity license plate frames and ham radio badges
etc. like you see at the swapmeets.  I don't compete with the locals who
are making a living doing that. Fred W7PRV

--- --- --- --- --- --- --- --- --- --- --- --- --- --
To subscribe: listserv at listserv.tempe.gov
and in body: subscribe BOATANCHORS yourfirstname yourlastname
To unsubscribe:  listserv at listserv.tempe.gov
and in body: signoff BOATANCHORS
Archives for BOATANCHORS: http://www.tempe.gov/archives
--- --- --- --- --- --- --- --- --- --- --- --- --- --