[cisco-bba] gigabit ethernet help
Sunet Sysadmin
sysadmin at sunet.com.au
Thu Aug 9 02:15:51 EDT 2007
Hi all,
thanks for the response and here is the out put of show commands. But
will be trying LX module on the week end and will keep you guys updated.
hadar#show run interface gigabitEthernet 1/0
Building configuration...
Current configuration : 168 bytes
!
interface GigabitEthernet1/0
description Data Link to Telstra
ip address 210.80.157.154 255.255.255.252
no ip redirects
no ip mroute-cache
negotiation auto
end
hadar#show interfaces gigabitEthernet 1/0
GigabitEthernet1/0 is up, line protocol is down
Hardware is WISEMAN, address is 0003.31a3.e41c (bia 0003.31a3.e41c)
Description: Data Link to Telstra
Internet address is 210.80.157.154/30
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex mode, link type is autonegotiation, *media type is unknown 23
* output flow-control is unsupported, input flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:09, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
cheers
phani.
Stavros Patiniotis wrote:
>Hello,
>
>
>
>>SX Modules are for MultiMode fibre connections. If you have SingleMode
>>fibres you need either a LX (1310nm) ~10km or a ZX (1550nm) ~ 40 km
>>module. Please ask the Telco (Telstra) what they required.
>>
>>
>
>Telstra normally have MMOF after the demarc point, although they can and do
>use SMOF too, but this is rare.
>
>You may want to check the interface settings:
>
>media-type gbic
>no negotiation auto
>
>If no success, send a 'sh int gi0/x' and 'sh run int gi0/x'.
>
>Cheers,
>
>Stavros Patiniotis
>EscapeNet ~ 08 8292 5200
>
>
>
*
*
More information about the cisco-bba
mailing list