[cisco-bba] Multiple virtual circuits over single link
ariev at vayner.net
Tue Oct 9 13:56:03 EDT 2012
It is technically possible, but as you do not operate the last mile
(BT...), not sure what services they could offer.
What you could do is create an IP overlay over the regular IP uplink... So
you have the PPPoE session for connectivity and the main service, and then
use a GRE tunnel terminating in the other service VRF on the CE device to
tunnel the traffic to where it should go on your infrastructure.
If you need Layer 2 extension, you could look at L2TPv3
On Tue, Oct 9, 2012 at 10:51 AM, Darren O'Connor <darrenoc at outlook.com>wrote:
> We currently have a couple of 7200 NPE-G2's running as LNS's terminating
> l2tp links from British Telecommunications (BT)
> Is it at all possible to run more than 1 virtual circuit over a single
> DSL/FTTC link?
> Basically sometimes customers of ours will be running 2 VRFs (guest
> wireless, whatever). It's very easy to separate these 2 VRFs over the WAN
> using subinterfaces on the primary ethernet link. However the DSL/FTTC
> backup interface can only be part of one VRF because there is only one
> Any ideas? I've tried to run multiple pppoe sessions over a DSL link
> before and it never allowed me to have more than 1 active at any one time.
> cisco-bba mailing list
> cisco-bba at puck.nether.net
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the cisco-bba