[cisco-nas] "annoying" output while "wr mem"

[James Parr]

You are using a T release and that is not really recommended unless 
you have to, but I don't think this issue is related to that.  I am 
not experienced with this error message at all, but I would recommend 
you verify you do not have any messed up commands in your config. 
Specifically I would say look at your modemcap and the line configs.

Sorry if this is not very specific, I hope this was enough help to 
get you in the right direction.

-- James


At 4:09 PM +0300 4/23/03, Tassos Chatzithomaoglou wrote:
>IOS (tm) 5300 Software (C5300-IS-M), Version 12.2(13)T3,  RELEASE 
>SOFTWARE (fc2)
>
>dial-ath-25#wr mem
>Building configuration...
>This command has no effect on this line; use modem AT commands 
>instead	<---------
>[OK]
>
>
>Is this supposed to be a bug?
>
>--
>***********************************
>    Chatzithomaoglou Anastasios
>Network Design & Operations Center
>           FORTHnet S.A.
>       <achatz at forthnet.gr>
>***********************************
>
>_______________________________________________
>cisco-nas mailing list
>cisco-nas at puck.nether.net
>http://puck.nether.net/mailman/listinfo/cisco-nas

-- 
James
Tomorrow will be cancelled due to lack of interest. - Anonymous
"Trying is the first step towards failure." - Homer Simpson