[cisco-nas] "annoying" output while "wr mem"

[Aaron Leonard]

This is CSCdz17325, fixed in 12.2(13.4)T (hence in 12.2(15)T.)
This is purely cosmetic, and I would not consider it to be a good
reason to change IOS.

Aaron

---

> You are using a T release and that is not really recommended unless
> you have to, but I don't think this issue is related to that.  I am
> not experienced with this error message at all, but I would recommend
> you verify you do not have any messed up commands in your config.
> Specifically I would say look at your modemcap and the line configs.

> Sorry if this is not very specific, I hope this was enough help to
> get you in the right direction.

> -- James


> At 4:09 PM +0300 4/23/03, Tassos Chatzithomaoglou wrote:
> >IOS (tm) 5300 Software (C5300-IS-M), Version 12.2(13)T3,  RELEASE
> >SOFTWARE (fc2)
> >
> >dial-ath-25#wr mem
> >Building configuration...
> >This command has no effect on this line; use modem AT commands
> >instead	<---------
> >[OK]
> >
> >
> >Is this supposed to be a bug?
> >
> >--
> >***********************************
> >    Chatzithomaoglou Anastasios
> >Network Design & Operations Center
> >           FORTHnet S.A.
> >       <achatz at forthnet.gr>
> >***********************************
> >
> >_______________________________________________
> >cisco-nas mailing list
> >cisco-nas at puck.nether.net
> >http://puck.nether.net/mailman/listinfo/cisco-nas

> --
> James
> Tomorrow will be cancelled due to lack of interest. - Anonymous
> "Trying is the first step towards failure." - Homer Simpson
> _______________________________________________
> cisco-nas mailing list
> cisco-nas at puck.nether.net
> http://puck.nether.net/mailman/listinfo/cisco-nas