[cisco-nas] WIC-1B-S/T "L1 deactivated"

[furda at bgs.sk]

Hi Daniel,

do you have the ISDN switch type configured globally? If not, configure it.

Richard

Quoting Daniel Roesen <dr at cluenet.de>:
> Hi,
> 
> I'm giving up (and now ask here). I'm trying to do some very basic
> DDR using a 3640 with WIC-1B-S/T on NM-2E2W:
> 
> Slot 3:
>         Combo 2E, 2W Port adapter, 4 ports
> ...
>         WIC Slot 1:
>         BRI S/T - 2186 WAN daughter card
>         Hardware revision 1.3           Board revision A0
>         Serial number     10368460      Part number    800-01833-02
>         Test history      0x0           RMA number     00-00-00
>         Connector type    Wan Module
> ...
> 
> interface BRI3/0
>  no ip address
>  encapsulation ppp
>  dialer map ip 192.168.17.1 123456
>  dialer-group 3
>  isdn switch-type basic-net3
>  ppp authentication chap
> end
> 
> but:
> 
> ISDN BRI3/0 interface
>         dsl 24, interface ISDN Switchtype = basic-net3
>     Layer 1 Status:
>         DEACTIVATED
>     Layer 2 Status:
>         Layer 2 NOT Activated
>     Layer 3 Status:
>         0 Active Layer 3 Call(s)
>     Active dsl 24 CCBs = 0
>     The Free Channel Mask:  0x80000003
>     Total Allocated ISDN CCBs = 0
> 
> "deb isdn q921" and shut/noshut did give no debug info at all.
> 
> Cisco IOS Software, 3600 Software (C3640-JS-M), Version 12.3(8)T6,
> RELEASE SOFTWARE (fc2)
> 
> I swapped cables, plugged the WIC directly into the NT, and even used
> another router (2621) with a different WIC-1B-S/T without success:
> 
> IOS (tm) C2600 Software (C2600-IK9O3S3-M), Version 12.3(12), RELEASE
> SOFTWARE (fc3)
> 
> What am I doing wrong? Other devices like an ISDN phone work flawlessly
> on the same S0 bus.
> 
> 
> Best regards,
> Daniel
> 
> -- 
> CLUE-RIPE -- Jabber: dr at cluenet.de -- dr at IRCnet -- PGP: 0xA85C8AA0
> _______________________________________________
> cisco-nas mailing list
> cisco-nas at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nas
> 


--