[cisco-nas] Virtaul-profile feature Set

[Oliver Boehmer (oboehmer)]

> I have a dialin user, which do not get an virtual
> interface. The radius config is relatively easy:
> 
> user01     Auth-Type:= Local, User-Password == "****""
>          Service-Type = Framed-User,
>          Framed-Protocol = PPP,
>          cisco-avpair += "ip:addr-pool=POOL_NETYOU_RFC",
>          Framed-Routing = None
> 
> Any ideas, why this user get no virtual-interface ?
> Wiht 12.2 there was no problems.

Apart from the fact that the user is terminated on the physical line, is there a problem? Can't check right now, but we shouldn't need an vaccess for this specific user. Is this an ISDN or Modem/async user?
remove the "virtual-profile if-needed" and you'll get a vaccess for every call..

	oli

>> Ahmad,
>> 
>> 
>>> I want to configure virtual profiles. These profiles
>>> shoul be used, when they are needed.
>>> Normally the configuration should look like this :
>>> 
>>> virtual-profile if-needed
>>> virtual-profile virtual-template 1
>>> virtual-profile aaa
>>> 
>>> Since my update from 12.2 to 12.3(T) the line
>>> "virtual-profile aaa" is away.
>>> 
>>> Any ideas, why this happen?
>>> Is this command not supported with IP Plus ?
>>> Is there a new way to configure this option ?
>> 
>> 
>> This command is obsolete, you don't need it anymore. IOS
>> automatically uses a vaccess when it sees per-user attributes in the
>> AAA response.. 
>> 
>> 	oli
> 
> 
> --
> Ahmad Cheikh-Moussa
> NetUSE AG
> Dr.-Hell-Straße, 24107 Kiel, Germany
> Telefon: +49 431 2390 400 --  Telefax: +49 431 2390 499
> Service: Service at NetUSE.DE --  http://NetUSE.DE/