[cisco-nas] AS5300 modems busied out - 12.3.18
Tassos Chatzithomaoglou
achatz at forthnet.gr
Fri May 26 04:35:35 EDT 2006
Hi Aaron,
Aaron Leonard wrote on 26/5/2006 2:54 πμ:
> Modem recovery can automatically busy out modems, if it should see
> excessive failures on certain modems and decide that it wants to
> "recover" the module.
>
I have neven seen on 12.2(15)T16 busied out calls (we're talking about 20 routers with this IOS),
although i get messages like:
May 25 04:00:00: %MODEM-1-MODEMOK: Modem (2/96) Running old firmware
May 25 04:38:00: %MICA-5-MODEM_RECOVERY: Modem (2/96) is being recovered by asap-redownload
May 25 04:38:06: %MODEM-5-DL_START: Modem (2/96) started firmware download
May 25 04:38:19: %MODEM-5-DL_GOOD: Modem (2/96) completed firmware download:
On the other hand, in 12.3.18 (only one router and in the same hunt group with the other 20), i
never got such messages, but i had quite a lot of busied out calls.
> There are probably some other reasons why the router will decide
> automatically to busy out modems, ... oh, I just though of one, that
> little featurette where where we proactively busy out modems to signal
> to the switch that the trunks are busy to force the switch to hunt to a
> different router.
>
Can you explain it a little bit more?
Why do you proactively busy out the modems in this case (signal to the switch), when the isdn
channels are the ones that should be busied out?
> Maybe if you look at the modem logs, they'll provide some explanation,
> unless they have rolled over past the busyout event.
>
I just reloaded the box :( and loaded 12.3.19....i'm waiting for busied out calls to appear again.
Then i'll try to grab the modem logs.
--
Tassos
> Aaron
>
> ------------------------------------------------------------------------
>
>
>> Router1 is AS5300 with 12.3(18.8) - 2.9.5.0
>>
>> router1>sh mode sum
>> Avg Hold Incoming calls Outgoing calls Busied Failed
>> No Succ
>> Time Succ Fail Avail Succ Fail Avail Out
>> Dial Ans Pct.
>> 00:32:21 65667 4330 91 0 0 0 54
>> 0 0 94%
>>
>> Router2 is AS5300 with 12.2(15)T16 - 2.9.5.0
>>
>> router2>sh modem sum
>> Avg Hold Incoming calls Outgoing calls Busied Failed
>> No Succ
>> Time Succ Fail Avail Succ Fail Avail Out
>> Dial Ans Pct.
>> 00:31:52 435989 25314 76 0 0 0 0
>> 0 4 95%
>>
>>
>> Router1 is the only AS5300 running 12.3(18.8) and is the only one
>> showing busied out calls during the last 2 months. Previously, when it
>> was running 12.2(15)T16 too, no busied calls were there for over a year.
>>
>> So, is there a known bug with "busied out" calls in 12.3.18 IOS? I
>> couldn't find anything in bugtool.
>>
>>
>> --
>> Tassos
>> _______________________________________________
>> cisco-nas mailing list
>> cisco-nas at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nas
>>
>
More information about the cisco-nas
mailing list