[cisco-nas] X.75 and modem dial-in, autocommand to TCP

[Aaron Leonard]

Glad you found it ... yes, you need "modem dialin" or "modem inout"
configured on your modem lines, for them to be willing to accept
incoming calls.

Cheers,

Aaron

------------------------------------------------------------------------

Gert Doering wrote:
> Hi,
>
> On Mon, May 11, 2009 at 02:59:18PM +0200, Gert Doering wrote:
>   
>> I'm stuck with modem calls, though.  Both the 3640 + NM-30DM and the
>> AS5300 that we bought in the mean time show the same error message upon
>> incoming modem calls ("debug isdn event" is active):
>>     
>
> OK.  More data.  "debug modem csm..." makes it say the following:
>
> May 11 14:59:08: VDEV_ALLOCATE: failed to allocate a device
> May 11 14:59:08: VDEV_ALLOCATE_ALMOST_READY: failed to allocate a non-idle modem
>
> ... but all modems are idle...
>
>
> ... and the solution was, as usual, quite obvious once I had found it
> (after quite a time of trying this and that and comparing with other
> configurations that did work)...
>
> line 1 120
>   modem dialin
>
> ... sow now I get incoming modem calls :-) (I'm not sure whether all
> the rest works nicely, like "flow control on large downloads" and such,
> but this will be tested next).
>
> thanks for listening :)
>
> gert
>
>