[nsp] enable commands as non-enable user?

[Josh Duffek]

just fyi...im 99% sure you cant do this for "sh run"...but i never tried for
"sh config".

joshd

----- Original Message -----
From: "Barry Bruins" <bbruins@cisco.com>
To: "Bruce Campbell" <bruce.campbell@ripe.net>; <cisco-nsp@puck.nether.net>
Sent: Monday, August 12, 2002 12:24 PM
Subject: Re: [nsp] enable commands as non-enable user?


> Use the privilege command to set the show running-config to another level.
>
> Barry
>
> At 06:29 PM 8/12/2002 +0200, Bruce Campbell wrote:
>
> >Greetings,
> >
> >I'm wanting to allow a dedicated non-enabled user to be able to 'show
> >conf' (run through all the routers and save the conf nightly).  Is this
> >possible via AAA (tacacs+)?  ( the AAA overview on cco isn't that clear
on
> >whether this is possible or not)
> >
> >--==--
> >Bruce.
> >
> >_______________________________________________
> >cisco-nsp mailing list  real_name)s@puck.nether.net
> >http://puck.nether.net/mailman/listinfo/cisco-nsp
> >archive at http://puck.nether.net/pipermail/cisco-nsp/
>