[c-nsp] rate limiting on 6500s ?

[ringwyrm27]

Did you put "set qos enable" before all these?  And did you put "commit qos 
acl all" second to last in the list below?




----- Original Message ----- 
From: "matthew zeier" <mrz at intelenet.net>
To: <cisco-nsp at puck.nether.net>
Sent: Wednesday, December 08, 2004 7:23 PM
Subject: [c-nsp] rate limiting on 6500s ?


>
> This is a 6500 running 7.6(1) on a Sup1 and MSFC.
>
> I have the following 20Mbps "cap" set -
>
> set qos policer aggregate twentymeglimit rate 20480 burst 256 drop
> set qos acl ip quick dscp 0 aggregate twentymeglimit ip any  any
> set qos acl map quick 9/9
>
> Is this syntax even right?
>
>
> cricket still shows spikes well above 20Mbps so I'm not clear if the 
> syntax is right or if the ACL is after the interface counters increment.
>
> --
> matthew zeier, Sr. Network Engineer  | "Nothing in life is to be feared.
> InteleNet Communications, Inc.       |  It is only to be understood."
> (949) 784-7904                       |       - Marie Curie
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/