[c-nsp] rate limiting on 6500s ?

[matthew zeier]

> Did you put "set qos enable" before all these?  And did you put "commit 
> qos acl all" second to last in the list below?

Yes, I just didn't paste that part in.



>
>
>
>
> ----- Original Message ----- 
> From: "matthew zeier" <mrz at intelenet.net>
> To: <cisco-nsp at puck.nether.net>
> Sent: Wednesday, December 08, 2004 7:23 PM
> Subject: [c-nsp] rate limiting on 6500s ?
>
>
>>
>> This is a 6500 running 7.6(1) on a Sup1 and MSFC.
>>
>> I have the following 20Mbps "cap" set -
>>
>> set qos policer aggregate twentymeglimit rate 20480 burst 256 drop
>> set qos acl ip quick dscp 0 aggregate twentymeglimit ip any  any
>> set qos acl map quick 9/9
>>
>> Is this syntax even right?
>>
>>
>> cricket still shows spikes well above 20Mbps so I'm not clear if the 
>> syntax is right or if the ACL is after the interface counters increment.
>>
>> --
>> matthew zeier, Sr. Network Engineer  | "Nothing in life is to be feared.
>> InteleNet Communications, Inc.       |  It is only to be understood."
>> (949) 784-7904                       |       - Marie Curie
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>