[nsp] Output errors on ATM interface

[Charles Sprickman]

On Wed, 2 Jun 2004, Niels Bakker wrote:

> Tried a "show controllers" to see what might be going on a few levels lower?

I hate to steal this thread, but since we're on the same track...

I see a number of input errors slowly increment on a PA-A3 card.  "sh
controllers" shows rx cells lost, but no lack of buffers:

Interface ATM4/0 is up
Hardware is ENHANCED ATM PA - DS3 (45000Kbps)
Framer is PMC PM7345 S/UNI-PDH, SAR is LSI ATMIZER II
Firmware rev: G137, Framer rev: 1, ATMIZER II rev: 3

Curr Stats:
  VCC count: current=1718, peak=1718
  AAL2 VCC count: 0
  AAL2 TX no buffer count: 0
  AAL2 RX no buffer count: 0
  SAR crashes: Rx SAR=0, Tx SAR=0
  rx_cell_lost=61787, rx_no_buffer=0, rx_crc_10=0
  rx_cell_len=0, rx_no_vcd=62916, rx_cell_throttle=0, tx_aci_err=0

Are the "rx_no_vcd" counts at all related to "rx_cell_lost"?  Or to the
input errors on the "sh int" output?

Thanks,

Charles


>
> 	-- Niels.
>
> --
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>