[nsp] APS manual switchover

Bruce Pinsky bep at whack.org
Mon Jun 21 19:05:04 EDT 2004


-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Dmitry Volkov wrote:

| What is the difference between "aps force" and "aps manual" ?
| it takes about 30 sec if I do switchover manually on 7500 POS OC3. Is it
| normal ?

~From the docs:

- - The "aps force" command has a higher priority than any of the signal
failures or the "aps manual" command.
- - Use the "aps force" command to manually switch the interface to a protect
interface when you are not using the "aps revert" command.


- - Use the "aps manual" command to manually switch the interface to a
protect interface.
- - If a protection switch is already up, you can also use the "aps manual"
command to revert the communication link back to the working interface
before the wait to restore (WTR) time has expired. The WTR time period is
set by the "aps revert" command.

- --
=========
bep

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.2 (MingW32)

iD8DBQFA12mgE1XcgMgrtyYRAl4MAJwKb3Yz6rNfZDgF+iiTBrh3bPDMcwCfTcWu
URlim6QutXJgKzIatZVKfVY=
=XCso
-----END PGP SIGNATURE-----


More information about the cisco-nsp mailing list