[nsp] APS manual switchover
Dmitry Volkov
dmitry.volkov at rogers.com
Mon Jun 21 19:20:18 EDT 2004
Well, thanks Bruce,
I read it before posting.
Doc is not very clear.
I tried both commands - and if forget about "higher priority" they work the
same
"you are not using the "aps revert" command..." I have revert configured and
aps force works
Again - 30 sec is it normal ?
Dmitry
> -----Original Message-----
> From: Bruce Pinsky [mailto:bep at whack.org]
> Sent: Monday, June 21, 2004 7:05 PM
> To: dmitry.volkov at rogers.com
> Cc: cisco-nsp at puck.nether.net
> Subject: Re: [nsp] APS manual switchover
>
>
> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
>
> Dmitry Volkov wrote:
>
> | What is the difference between "aps force" and "aps manual" ?
> | it takes about 30 sec if I do switchover manually on 7500
> POS OC3. Is it
> | normal ?
>
> ~From the docs:
>
> - - The "aps force" command has a higher priority than any of
> the signal
> failures or the "aps manual" command.
> - - Use the "aps force" command to manually switch the
> interface to a protect
> interface when you are not using the "aps revert" command.
>
>
> - - Use the "aps manual" command to manually switch the interface to a
> protect interface.
> - - If a protection switch is already up, you can also use
> the "aps manual"
> command to revert the communication link back to the working interface
> before the wait to restore (WTR) time has expired. The WTR
> time period is
> set by the "aps revert" command.
>
> - --
> =========
> bep
>
> -----BEGIN PGP SIGNATURE-----
> Version: GnuPG v1.2.2 (MingW32)
>
> iD8DBQFA12mgE1XcgMgrtyYRAl4MAJwKb3Yz6rNfZDgF+iiTBrh3bPDMcwCfTcWu
> URlim6QutXJgKzIatZVKfVY=
> =XCso
> -----END PGP SIGNATURE-----
More information about the cisco-nsp
mailing list