[nsp] Ethernet Errors - 6509

[Paul Stewart]

Thanks.. Much to my surprise, my original posting had stated that the CVX
was hard coded to 100Full when in fact it was set to defaults (which I
thought were 100Full) and turns out to be 100 Half... Hard coded on both
sites 100 full and no errors now...

:)

Paul


-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Wojtek Zlobicki
Sent: Sunday, May 30, 2004 8:44 PM
To: cisco-nsp at puck.nether.net
Subject: RE: [nsp] Ethernet Errors - 6509


I would also recommend that you play with the auto/full on both sides. While
the general rule states that Auto is bad, it is the only way that works
between vendors. How long is the cable between the port and the PBX.  Could
be a bad port/network card. 

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Richard Danielli -
eSubnet
Sent: Thursday, May 27, 2004 1:59 PM
To: cisco-nsp at puck.nether.net
Subject: RE: [nsp] Ethernet Errors - 6509

Paul,

You have stated that one side is fixed 100 fd and the other is  set 100 fd

I would consider tweaking the cable, have you tested that it is Cat 5
compliant (pin outs and length)

If that doesn't help, try setting the Cat 6500 to half duplex,  see what
that does.

-rd-
--
Richard Danielli
Founder/President
eSubnet Enterprises Inc.
TORONTO, ON
Canada
(416) 203-5253
c: (416) 525-6148
http://www.eSubnet.com

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/



_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/