[c-nsp] device shows no link on 6509, but works on other switches

[Brian Turnbow]

Most dells have auto mdix, try a cross cable to connect to the 6509.
Regards
Brian 

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Burton Windle
Sent: venerdì 22 ottobre 2004 16.54
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] device shows no link on 6509, but works on other switches

ok, this is odd.. we have a vendor with a weird device (PelcoNet 350) that will not give us a link light (or pass traffic) when plugged into our 6509's WS-X6348-RJ-45 blade. If we try a Cisco VoIP phone or a regular laptop, using the same cable into the same port, we get a link light and traffic flows fine.

However, the Pelco device gets a link and passes traffic when plugged into a Dell PowerConnect 2616 switch, or into an old 3com switch.

I have tried hard-setting duplex and port speed, but to no avail; we never see a link light on either end, and the port status always shows as 'notconnect'. Any ideas?


5   48   WS-X6348-RJ-45      SAL0718CFZ1 Hw : 6.5
                                         Fw : 5.4(2)
                                         Sw : 6.4(10)
         WS-F6K-VPWR                     Hw : 2.0



-- 
Burton Windle                           bwindle at fint.org

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/