[c-nsp] device shows no link on 6509, but works on other switches

[Dave Breiland]

I'm not saying it makes sense... but have you tried a cross-over cable?
Have you verified it can do full-duplex ... 100mbps?  Perhaps the hard
coding was set to the wrong combo. 

Let us know what you end up figuring out!

Dave

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Burton Windle
Sent: Friday, October 22, 2004 7:54 AM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] device shows no link on 6509, but works on other switches

ok, this is odd.. we have a vendor with a weird device (PelcoNet 350) that
will not give us a link light (or pass traffic) when plugged into our
6509's WS-X6348-RJ-45 blade. If we try a Cisco VoIP phone or a regular
laptop, using the same cable into the same port, we get a link light and
traffic flows fine.

However, the Pelco device gets a link and passes traffic when plugged into
a Dell PowerConnect 2616 switch, or into an old 3com switch.

I have tried hard-setting duplex and port speed, but to no avail; we never
see a link light on either end, and the port status always shows as
'notconnect'. Any ideas?


5   48   WS-X6348-RJ-45      SAL0718CFZ1 Hw : 6.5
                                         Fw : 5.4(2)
                                         Sw : 6.4(10)
         WS-F6K-VPWR                     Hw : 2.0



-- 
Burton Windle                           bwindle at fint.org

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/