[c-nsp] Cat 6500 and counters

[Dale W. Carder]

On Apr 27, 2005, at 4:14 PM, Jay Ford wrote:
>
>> What about the interface counters?
>
> The counters on physical interfaces & vlan interfaces seem to work.  
> The
> counters on sub-ints don't work.


Good news, 12.2(18)SXE and later releases support these features on LAN 
port subinterfaces:

  –
-------------- next part --------------
IPv4 unicast forwarding, including MPLS VPN
  –
-------------- next part --------------
IPv4 multicast forwarding, including MPLS VPN
  –
-------------- next part --------------
6PE
  –
-------------- next part --------------
EoMPLS
  –
-------------- next part --------------
IPv4 unnumbered
  –
-------------- next part --------------
Counters for subinterfaces in MIBS and with the show vlans command
  –
-------------- next part --------------
iBGP and eBGP
  –
-------------- next part --------------
OSPF
  –
-------------- next part --------------
EIGRP
  –
-------------- next part --------------
RIPv1/v2
  –
-------------- next part --------------
RIPv2
  –
-------------- next part --------------
ISIS
  –
-------------- next part --------------
Static routing
  –
-------------- next part --------------
Unidirectional link routing (UDLR)
  –
-------------- next part --------------
IGMPv1, IGMPv2, IGMPv3
  –
-------------- next part --------------
PIMv1, PIMv2
  –
-------------- next part --------------
SSM IGMPv3lite and URD
  –
-------------- next part --------------
Stub IP multicast routing
  –
-------------- next part --------------
IGMP join
  –
-------------- next part --------------
IGMP static group
  –
-------------- next part --------------
Multicast routing monitor (MRM)
  –
-------------- next part --------------
Multicast source discovery protocol (MSDP)
  –
-------------- next part --------------
SSM
  –
-------------- next part --------------
IPv4 Ping
  –
-------------- next part --------------
IPv6 Ping

These restrictions apply to releases earlier than Release 12.2(18)SXE:
  –
-------------- next part --------------
Configure subinterfaces only to support MPLS.
  –
-------------- next part --------------
Do not configure ISL encapsulation.


Dale

-----------------------------------------------
Dale W. Carder
Network Engineer
University of Wisconsin at Madison
http://net.doit.wisc.edu/~dwcarder