[c-nsp] Trouble with a NM-2CT1-CSU module

[Bruce Pinsky]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Eric Kagan wrote:
| Confirm the router with the CT controller card is set to 64k not 56k.  There
| is a speed command option on the controller channel-group.  I get burned
| with this on the VWIC-xMFT-T1 all the time !
|
| controller T1 1/1
| <snip>
| channel-group 0 timeslots 1-24  speed 64  <---- note speed 64.  I think
| default is 56k.
|

Ah, yes a good point.  As mentioned at:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/dial_r/dia_c1g.htm#wp1108669

the default is 56K and the output of the "show service-module" confirms 64K
channels:

rio_rancho_management_router#show service-module Serial0/1
Module type is T1/fractional
~    Hardware revision is 0.96, Software revision is 0.2,
~    Image checksum is 0xED22BEC5, Protocol revision is 0.1
Receiver has no alarms.
Framing is ESF, Line Code is B8ZS, Current clock source is line,
Fraction has 24 timeslots (64 Kbits/sec each), Net bandwidth is 1536
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^

This mismatch would certainly cause a framing error :-)

- --
=========
bep

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.0 (MingW32)

iD8DBQFC8VyRE1XcgMgrtyYRAiApAJ0a13s5yQthadxDiTwGQDFdDIQBcgCeM+IC
UNXUbqZ0FFmu3MysTH42xYE=
=DxTy
-----END PGP SIGNATURE-----