[c-nsp] Trouble with a NM-2CT1-CSU module

[James Edwards]

> Ah, yes a good point.  As mentioned at:
> 
> http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/dial_r/dia_c1g.htm#wp1108669
> 
> the default is 56K and the output of the "show service-module" confirms 64K
> channels:
> 
> rio_rancho_management_router#show service-module Serial0/1
> Module type is T1/fractional
> ~    Hardware revision is 0.96, Software revision is 0.2,
> ~    Image checksum is 0xED22BEC5, Protocol revision is 0.1
> Receiver has no alarms.
> Framing is ESF, Line Code is B8ZS, Current clock source is line,
> Fraction has 24 timeslots (64 Kbits/sec each), Net bandwidth is 1536


But on the other side:

Serial1/0:0 is up, line protocol is down
|   Hardware is DSX1
|   Description: T-1 to RR colo
|   Internet address is 10.444.0.25/30
|   MTU 1500 bytes, ********BW 1344****** Kbit, DLY 20000 usec,
|      reliability 229/255, txload 1/255, rxload 1/255
|   Encapsulation FRAME-RELAY IETF, loopback not set

Yep, it was set to 56k ! It came right up, of course, once 
both sides agreed on DS0's spec. 

Thanks, everyone !

j