[c-nsp] Trouble with a NM-2CT1-CSU module

Bruce Pinsky bep at whack.org
Thu Aug 4 02:07:10 EDT 2005


-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

James Edwards wrote:
|>Ah, yes a good point.  As mentioned at:
|>
|>http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/dial_r/dia_c1g.htm#wp1108669
|>
|>the default is 56K and the output of the "show service-module" confirms 64K
|>channels:
|>
|>rio_rancho_management_router#show service-module Serial0/1
|>Module type is T1/fractional
|>~    Hardware revision is 0.96, Software revision is 0.2,
|>~    Image checksum is 0xED22BEC5, Protocol revision is 0.1
|>Receiver has no alarms.
|>Framing is ESF, Line Code is B8ZS, Current clock source is line,
|>Fraction has 24 timeslots (64 Kbits/sec each), Net bandwidth is 1536
|
|
|
| But on the other side:
|
| Serial1/0:0 is up, line protocol is down
| |   Hardware is DSX1
| |   Description: T-1 to RR colo
| |   Internet address is 10.444.0.25/30
| |   MTU 1500 bytes, ********BW 1344****** Kbit, DLY 20000 usec,
| |      reliability 229/255, txload 1/255, rxload 1/255
| |   Encapsulation FRAME-RELAY IETF, loopback not set
|
| Yep, it was set to 56k ! It came right up, of course, once
| both sides agreed on DS0's spec.
|
| Thanks, everyone !
|

Thanks to Eric for pointing out the obvious and glad it's working now!


- --
=========
bep

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.0 (MingW32)

iD8DBQFC8bCOE1XcgMgrtyYRAjGLAKDC+N82OLtqAmh/0fC/fn2ky978nACgyKSd
DG+Y0aBSu3SWx2Q9DvOttzg=
=sbCL
-----END PGP SIGNATURE-----


More information about the cisco-nsp mailing list