[c-nsp] 3550 QoS not working as expected

[Tim Devries]

I thought it might need to be a layer three interface before it would accept
the command as well.  That doesn't seem to work though unfortunately.  

Thanks,

Tim
 

-----Original Message-----
From: Nick Shah
To: Tim Devries; cisco-nsp at puck.nether.net
Sent: 1/6/05 8:50 PM
Subject: RE: [c-nsp] 3550 QoS not working as expected



I seriously doubt that rate limit (as in rate limit command) isnt
supported. Rate limiting (as in policing) is supported and the way to do
it is by using individual & aggregate policers.

You could though try it to make a spare routed port (no switchport) and
then try it.

interface FastEthernet0/6
 no switchport
 ip address x.y.z.a 255.255.255.x
 rate-limit <blah>
end

rgds
-----Original Message-----
From: Tim Devries [mailto:tdevries at northrock.bm] 
Sent: Friday, 7 January 2005 11:27 AM
To: Nick Shah; Tim Devries; 'cisco-nsp at puck.nether.net '
Subject: RE: [c-nsp] 3550 QoS not working as expected


 
There is no non-IP traffic, and I did a sh arp/verified the interface
IP's in the ACL.  I'm going to try it for the sake of it, though if I've
got arp entries that aren't showing that might be a bigger problem ;-0

I guess if that fails I will be trying another version over the weekend,
and I'll see if that helps.

I would also like rate-limiting to work, because according to

http://www.cisco.com/en/US/products/hw/switches/ps646/ps3816/index.html

"For the first time, customers can deploy network-wide intelligent
services, such as advanced quality of service (QoS), **rate-limiting**,
Cisco security access control lists, multicast management, and
high-performance IP routing-while maintaining the simplicity of
traditional LAN switching."

...it should, but I've been unable to find how, and the usual command
set doesn't seem to work.  Am I missing something here?  My immediate
thoughts are that perhaps something other than traditional rate-limiting
commands is implied?

Thanks,

Tim


------------------------------------------------------------------------
------
This communication, including any attachments, is confidential. If 
 you are not the intended recipient, you should not read it - please 
 contact me immediately, destroy it, and do not copy or use any part of 
 this communication or disclose anything about it.

------------------------------------------------------------------------
------