[c-nsp] Re: 6500 Port Monitor

[Justin M. Streiner]

On Wed, 19 Jan 2005, Tim Stevenson wrote:

> This problem has to do with the particular line card you are using for the
> span destination ports, ie, one of the 8:1 oversubscribed GETX blades.
>
> There are two solutions to your problem: either move the gig and 100M SPAN
> dest ports to 2 different muxing ASICs on this module (eg, port 1 & port 9,
> they are in contiguous groups of 8 ports); or, upgrade to 12.1(26)E, where
> this problem is resolved.

By chance would this same fix apply to the same problems with 48-port 
FE/TX blades in the 6500s?  I've run into problems in the past where I 
couldn't span to or from a port if there was a pvlan port configured in 
the same ASIC bundle...

jms