[c-nsp] Routing packets between two VPNs terminating on the samePIX

[Joe Maimon]

Heaven forbid the PIX should ever act like a router.

Net Guru wrote:
> Hi!,
>                 One small doubt, the link of the below cisco site says that PIX can enable packet forwarding between interfaces with same security level with the help of same-security-traffic command. But does that mean that if one packet comes inside the PIX via one interface say "Outside" the packet can again go out of the PIX via the same interface ?
> 
> regards,
> NG
> 
>   ----- Original Message ----- 
>   From: Matti Saarinen 
>   To: cisco-nsp at puck.nether.net 
>   Sent: Friday, July 01, 2005 3:16 PM
>   Subject: Re: [c-nsp] Routing packets between two VPNs terminating on the samePIX
> 
> 
> 
>   "Mark Kelly" <mkelly at dataelec.com> writes:
> 
>   > Depends on what version of PIX OS your running.  Versions prior to 7.0
>   > cannot do what you require.
> 
>    It's 6.3(3). So, we need to upgrade. I wish 7.0 is stable enough.
> 
>    I got a private email, too, in which there was an url pointing to the
>    appropriate manual section:
> 
>   http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_70/cref_txt/s.htm#wp2233475
> 
> 
>    Thank you,
> 
>   -- 
>   - Matti -
>   _______________________________________________
>   cisco-nsp mailing list  cisco-nsp at puck.nether.net
>   https://puck.nether.net/mailman/listinfo/cisco-nsp
>   archive at http://puck.nether.net/pipermail/cisco-nsp/
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
> 
>