[c-nsp] VRF's

[Ryan O'Connell]

On 15/03/2005 20:32, Geoffrey Cauchi wrote:

>I am trying a config on a 7206 router where I have two Ethernet
>interfaces, g0/2 and g0/3.  I would like to have the traffic go out of
>g0/2, into a device that will analyze the traffic.  The router will see
>this device as a layer 2 bridge, so it can be considered as a simple
>cross over cable between ports g0/2 and g0/3.
>
>G0/3 will be in a VRF.  Such a config works if the interfaces are for
>example E3 interfaces, but I cannot get the config to work with Ethernet
>interfaces.
>  
>

What does your config look like? I've sucessfully used a "VLAN Snake 
test" arrangement except with VRFs to successfully test multiple suspect 
PA-2FEs under load so I know it works in principle...

-- 
         Ryan O'Connell - CCIE #8174
<ryan at complicity.co.uk> - http://www.complicity.co.uk

I'm not losing my mind, no I'm not changing my lines,
I'm just learning new things with the passage of time