[c-nsp] 7200VXR- pa-mc-8t1

[Eric Kagan]

> Im in the US and I'm using the PA-MC-8T1 however, I cant seem 
> to set the frame-relay interface and set my point to point's. 
>  I have created the channel group's however, I cant set the 
> frame-relay commands..  

Frame commands follow the serial interfaces, not the controllers.

Also, encap frame will need to be set first on the interface


Int s2/0:0.x point
Encaps frame-relay
Frame-relay xxxx

Eric

> 
> -----Original Message-----
> From: Bruce Pinsky [mailto:bep at whack.org] 
> Sent: Friday, March 25, 2005 1:46 PM
> To: Scott Ingram
> Cc: cisco-nsp at puck.nether.net
> Subject: Re: [c-nsp] 7200VXR- pa-mc-8t1
> 
> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
> 
> Scott Ingram wrote:
> | Ok,
> | I tried to make these command changes:
> |
> | Controller T1 2/0
> | All I can do is change:
> | esf  Extended Superframe
> |   sf   Superframe
> |
> | Am I missing something or do I have the wrong card ?
> |
> 
> If you need E1, then you have the wrong card.  The is for T1 
> only.  For E1, you would need the PA-MC-8E1.  See 
> http://www.cisco.com/en/US/products/hw/modules/ps2033/products
_data_shee
t09186a0080091d10.html

- --
=========
bep

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.0 (MingW32)

iD8DBQFCRFxNE1XcgMgrtyYRAqZLAJ9wM5jh9b0IFgKzeCBu+XkohTOxDgCdFOTC
n9eSeTV/b3Nm4wlJPcTn0vA=
=GUxf
-----END PGP SIGNATURE-----

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/