[c-nsp] 7200VXR- pa-mc-8t1

[Eric Kagan]

Sorry I typed quicker than I was thinking.... Corrected below:

> > Im in the US and I'm using the PA-MC-8T1 however, I cant seem
> > to set the frame-relay interface and set my point to point's. 
> >  I have created the channel group's however, I cant set the 
> > frame-relay commands..  
> 
> Frame commands follow the serial interfaces, not the controllers.
> 
> Also, encap frame will need to be set first on the interface
> 
> 
Interface s2/0:0
Encaps frame-relay

Int s2/0:0.1 point
Frame-relay interface-dlci xxx

Eric

> > 
> > -----Original Message-----
> > From: Bruce Pinsky [mailto:bep at whack.org]
> > Sent: Friday, March 25, 2005 1:46 PM
> > To: Scott Ingram
> > Cc: cisco-nsp at puck.nether.net
> > Subject: Re: [c-nsp] 7200VXR- pa-mc-8t1
> > 
> > -----BEGIN PGP SIGNED MESSAGE-----
> > Hash: SHA1
> > 
> > Scott Ingram wrote:
> > | Ok,
> > | I tried to make these command changes:
> > |
> > | Controller T1 2/0
> > | All I can do is change:
> > | esf  Extended Superframe
> > |   sf   Superframe
> > |
> > | Am I missing something or do I have the wrong card ?
> > |
> > 
> > If you need E1, then you have the wrong card.  The is for T1
> > only.  For E1, you would need the PA-MC-8E1.  See 
> > http://www.cisco.com/en/US/products/hw/modules/ps2033/products
> _data_shee
> t09186a0080091d10.html
> 
> - --
> =========
> bep
> 
> -----BEGIN PGP SIGNATURE-----
> Version: GnuPG v1.4.0 (MingW32)
> 
> iD8DBQFCRFxNE1XcgMgrtyYRAqZLAJ9wM5jh9b0IFgKzeCBu+XkohTOxDgCdFOTC
> n9eSeTV/b3Nm4wlJPcTn0vA=
> =GUxf
> -----END PGP SIGNATURE-----
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net 
> https://puck.nether.net/mailman/listinfo/cisco> -nsp
> archive at 
> http://puck.nether.net/pipermail/cisco-nsp/
> 
> 
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net 
> https://puck.nether.net/mailman/listinfo/cisco> -nsp
> archive at 
> http://puck.nether.net/pipermail/cisco-nsp/
>