[c-nsp] Rate limitting question
Bartosz Piec
cisco at piec.info
Wed Oct 12 10:21:34 EDT 2005
Andris Zarins napisał(a):
> Check at CCO if it supports per 'interface VLAN' QoS actions.
How?
> My recommendation is to use not 'interface vlan xxx', but 'interface FastErhternetx/x.xx', meaning - dot1q subinterface for some physical interface.
FE interefaces are L2 links. They work as a switch. Assigning IP for
them is available only by setting VLAN. I think that assigning policy
isn't also possible ("%Error: FastEthernet0/3/3 Service Policy
Configuration Failed. Check policer rate in policy-map : TEST, class-map
: TEST").
Then configure required QoS actions using MQC.
> Class-map
> Match xxx
> Policy-map yyy
> Class xxx
> Police 128
> Class class-default
> Interface z/z.zz
> Service-policy input[output] yyy
What's the difference between this and shaping? And CAR? :) What's the
best to configure?
--
Best regards,
Bartosz Piec
More information about the cisco-nsp
mailing list