[c-nsp] Really need help with atm vc-per-vp on NM-4T1 3640

[Ruben Alvarez]

Anyone else?  The bug was early in 12.2.  It's not related to the bug.
Also, I can't remove the command either.  I try a "no atm vc-per-vp 1024."
It behaves like to accepted the command, but it still shows up when I do a
"sh int."  

-----Original Message-----
From: Brian Turnbow [mailto:b.turnbow at twt.it] 
Sent: Friday, February 03, 2006 2:51 AM
To: Ruben Alvarez; cisco-nsp at puck.nether.net
Subject: RE: [c-nsp] Really need help with atm vc-per-vp on NM-4T1 3640

Basically this command robs bits from the vp side to use in the vc side.
It limits teh vps you can then use ie 512 only allows you to have vp values
0-15 64-79 
There was a bug related to this command that was resolved somewhere in 12.2,
but I don't remrember when.

Brian

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Ruben Alvarez
Sent: venerdì 3 febbraio 2006 2.06
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] Really need help with atm vc-per-vp on NM-4T1 3640

All.

I'm having a really hard time getting this command to work.  As I
understand, I should be able to adjust the number of maximum active VCs that
module will allow.  Currently, it is allowing 255 maximum VCs.  I'm using
IOS 12.2(32) GD.

I'll shut all 4 of the interfaces and apply the command.  It looks like the
command is applied, but the value for maximum active VCs does not change.
If I do a show interface, I see that the command is in the interface,
vc-per-vp 512.

There's not much documentation of this command.  Anyone have any experience
with this?

Thanks
Ruben Alvarez
Opus:interactive



_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/