[c-nsp] More than 2 FE on 26xx possible?

[Ian Henderson]

On Mon, 13 Feb 2006, Jeremy Hinton wrote:

> 	Subject says it all. Is it in any way possible (via NM/WICs/etc) to get
> more than 2 fast ethernet ports on a 26xx platform router? If so, what

I've used NM-4E and NM-FE in 2600s. I don't believe WIC-1ENET works
though.

This box is a 2620XM (so single FE on board) that we needed to upgrade,
but didn't have any dual-FE routers handy.

System image file is "flash:c2600-ik9o3s3-mz.123-15.bin"
cisco 2620XM (MPC860P) processor (revision 0x100) with 59392K/6144K bytes
of memory.

Slot 1:
        Fast-ethernet Port adapter, 1 port
        Port adapter is analyzed
        Port adapter insertion time unknown
        EEPROM contents at hardware discovery:
        Hardware revision 1.0           Board revision G0
        Serial number     19193700      Part number    800-03490-02
        FRU Part Number:  NM-1FE-TX=

        Test history      0x0           RMA number     00-00-00
        EEPROM format version 1
        EEPROM contents (hex):
          0x00: 01 44 01 00 01 24 DF 64 50 0D A2 02 00 00 00 00
          0x10: 80 00 00 00 00 04 13 00 FF FF FF FF FF FF FF FF

Interface                  IP-Address      OK? Method Status                Protocol
FastEthernet0/0            x.x.x.x         YES manual up                    up
FastEthernet1/0            x.x.x.x         YES manual up                    up

--
Ian Henderson, CCIE #14721
Senior Network Engineer

iiNet Limited
Chime Communications Pty Ltd