[c-nsp] "Unrecognized cookie format" for WIC-1DSU-T1

[neal rauhauser]

  Is it a WIC-1DSU-T1? And you need a WIC-1DSU-T1-V2 for the 18xx/28xx/38xx
series ... if it came out of an older router this is likely the case.



On 8/28/07, Ed Ravin <eravin at panix.com> wrote:
>
> We just stuck a WIC-1DSU-T1 removed from service on a different
> router into a 2801.  The router says this upon bootup:
>
> %CFG-3-CARD_NOT_SUPPORTED: Slot 3: Unrecognized cookie format for
> card!sslinit fn
>
> The version info is:
>
> Cisco IOS Software, 2801 Software (C2801-ADVSECURITYK9-M), Version 12.4(3f),
> RELEASE SOFTWARE (fc3)
>
>
> What could be going on here?  We tried all three WIC slots, same
> error.  Is something basic like T1 WIC support missing from the image,
> or do I have a bad or fake WIC?  The "show diag" info is below:
>
>         WIC/VIC/HWIC Slot 3:
>         FT1 BT8360
>         WIC module not supported/disabled in this slot
>         Hardware revision 1.3           Board revision C0
>         Serial number     28156561      Part number    800-03279-04
>         FRU Part Number   WIC-1DSU-T1=
>
>         Test history      0x0           RMA number     00-00-00
>         Connector type    Wan Module
>         EEPROM format version 2
>         EEPROM contents (hex):
>           0x20: 02 11 01 03 01 AD A2 91 50 0C CF 04 00 00 00 00
>           0x30: 60 00 00 00 02 05 14 01 FF FF FF FF FF FF FF FF
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>