[c-nsp] RE. Cisco 3750 Rate limit

[Michalis Palis]

Hello all

I configure a policer to limeit traffic to 50Mbs as below but as soon as I 
apply the service policy, their is a traffic drop on the interface. Any 
suggestion?

Here is my config


mls qos
!
class-map match-any test-policing
  match access-group 100
!
!
policy-map test-policing
  class test-policing
    police 50000000 20000 exceed-action drop

interface GigabitEthernet1/0/12
 switchport access vlan 261
 switchport mode access
 service-policy input test-policing

access-list 100 permit ip any any

 Any suggestion??
 Thanks
----- Original Message ----- 
From: "Raymond Macharia" <rmacharia at gmail.com>
To: "Rooney, Randy" <Randy.Rooney at integratelecom.com>
Cc: <cisco-nsp at puck.nether.net>
Sent: Thursday, December 06, 2007 11:27 AM
Subject: Re: [c-nsp] Cisco 3400 ME switch with DC power


> hi Randy,
> because the switches will be located in POPs with less than good AC power
> and cooling DC was the better option.
> By the way the DC version has also a higher MTBF.
> I only found it strange that Cisco has not provisioned a power supply for 
> it
> like for other devices.
>
> Raymond
>
> On Dec 5, 2007 6:17 PM, Rooney, Randy <Randy.Rooney at integratelecom.com>
> wrote:
>
>> Why not buy the AC version?
>>
>> Cisco ME 3400-24TS AC with 24 Ethernet 10/100 ports, two SFP uplinks,
>> and an AC power supply (part number ME-3400-24TS-A)
>>
>> Randy
>>
>> > -----Original Message-----
>> > From: cisco-nsp-bounces at puck.nether.net
>> > [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of
>> > Raymond Macharia
>> > Sent: Wednesday, December 05, 2007 6:17 AM
>> > To: cisco-nsp at puck.nether.net
>> > Subject: [c-nsp] Cisco 3400 ME switch with DC power
>> >
>> > Hello,
>> > does anyone know where I can get an AC to DC power rectifier
>> > for the ME 3400 Switch.
>> > there are plenty of them out there but not for this switch. I
>> > have been trying to get info from the Cisco guys locally
>> > without any headway.
>> > The specific switch is a Cisco ME 3400-24TS DC.
>> > The power requirements in the data sheet are :
>> >
>> > *Power consumption**
>> > 25W (typical), 30W (maximum), 102 Btus per hour
>> >
>> > DC Input Voltage
>> >  DC: -36  -72 VDC, 2.0 to 1.0A
>> >
>> > *Thanks in advance*
>> > *--
>> > Raymond Macharia
>> > _______________________________________________
>> > cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> > https://puck.nether.net/mailman/listinfo/cisco-nsp
>> > archive at http://puck.nether.net/pipermail/cisco-nsp/
>> >
>>
>
>
>
> -- 
> Raymond Macharia
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/