[c-nsp] Cisco 6509 VRRP no preemption

[Tolstykh, Andrew]

Please post the output of the VRRP interface configuration and "show
vrrp all" commands.

By default VRRP will preempt for all configured groups.
You need to disable preemption explicitly with no vrrp [group] preempt.


By default, a preemptive scheme is enabled whereby a higher priority
virtual router backup that becomes available takes over for the virtual
router backup that was elected to become virtual router master. You can
disable this preemptive scheme using the no vrrp preempt command. If
preemption is disabled, the virtual router backup that is elected to
become virtual router master remains the master until the original
virtual router master recovers and becomes master again. 


ISP1-INET-RTR1#sho vrrp all 
FastEthernet0/0 - Group 1  
  State is Master  
  Virtual IP address is 160.1.1.2
  Virtual MAC address is 0000.5e00.0101
  Advertisement interval is 1.000 sec
  Preemption enabled
  Priority is 100 
  Master Router is 160.1.1.1 (local), priority is 100 
  Master Advertisement interval is 1.000 sec
  Master Down interval is 3.609 sec

no vrrp 1 preempt

ISP1-INET-RTR1#sho vrrp all 
FastEthernet0/0 - Group 1  
  State is Master  
  Virtual IP address is 160.1.1.2
  Virtual MAC address is 0000.5e00.0101
  Advertisement interval is 1.000 sec
  Preemption disabled
  Priority is 100 
  Master Router is 160.1.1.1 (local), priority is 100 
  Master Advertisement interval is 1.000 sec
  Master Down interval is 3.609 sec


-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Gier, Menno de
(Menno)
Sent: Tuesday, July 31, 2007 2:25 PM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] Cisco 6509 VRRP no preemption

All,

We have two Cisco 6509 switches (A1 and A2) running VRRP over a trunk
between both switches. We have configured VRRP with no vrrp preemption.

After a power down of switch A1, which was selected as master VRRP, the
VRRP moved to the switch A2, as it should be.

After power up it of the switch A1 it became Master for the VRRP again
and the other switch A2 became backup unexpectedly.

Is this normal behavior of VRRP after a reboot?

We have configured VRRP to be non preemption to avoid a second traffic
interruption. We want to have the switch-over taking place in service
hours under our control.

Thanks in advance,

/mg 

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
The information transmitted is intended only for the person or entity to which it is addressed and may contain confidential
and/or privileged material.  Any review, retransmission, dissemination or other use of, or taking of any action in reliance upon,
this information by persons or entities other than the intended recipient is prohibited.   If you received this in error, please
contact the sender and delete the material from any computer.